DCS RGSC-305 - Top Assembly; Cooling Fan Motor

PRELIMINARY
28
COMPONENT ACCESS
TOP ASSEMBLY
1. Pull oven away from wall,making sure gas supply is
turned off at the valve,and gas line and electrical are
disconnected.
2. Remove the four (4) phillips head screws from island
trim where it attaches to the back panel (fig.56).
3. Remove the all knobs and then the four (4) #15 torx
head screws from control panel front (fig.54).
4. Remove upper burner assemblies and remove top
from unit. (See page 17 burner disassembly).
5. Remove wire guard and trim assembly from front of
unit. (fig’s 57 & 58).
6. Remove the four (4) phillips head screws from bull
nose trim assembly,two on either side (fig.59).
7.Pull thermo bulbs from oven cavity
8. Lift top up to a 45 degree angle and pull straight
towards you.
COOLING FAN MOTOR
1. Pull oven away from wall,making sure gas supply is
turned off at the valve,and gas line and electrical are
disconnected.
2. Remove the four (4) phillips head screws from island
trim where it attaches to the back panel (fig.56).
3. Remove the four knobs and then the four (4) #15 torx
head screws from control panel front (fig.54).
4. Remove upper burner assemblies and remove top
from unit. (See page 17 burner disassembly).
Fig. 56
Fig. 58
Fig. 57
Fig. 59
4 phillips head
screws