Message
Solution
Message
Cause
Solution
Message
Cause
Solution
Message
Solution
Message
6.1.22 Message: Piston blocked, dosage too high
Piston blocked, dosage too high.
Perform the following steps to solve the problem:
1. Open and close the door of the coffee machine to initialize
the brewer.
2. Check correct functioning by taking a coffee beverage. If
problem persists: Consult the service engineer (see
Service
and support on page 3).
6.1.23 Message: Place cup in center
Place cup in center
Cup needs to be placed under the correct dispensing nozzle
before the [Start] button is available.
Perform the following steps to solve the problem:
1.
If cup is placed in the correct position clean the cup sensor.
6.1.24 Message: Place cup right
Place cup right
Cup needs to be placed under the water dispensing nozzle before
the [Start] button is available.
Perform the following steps to solve the problem:
1. If cup is placed in the correct position clean the cup sensor.
6.1.25 Message: Please load configuration
Please load configuration
Perform the following steps to solve the problem:
Consult the service engineer (see
Service and support on page
3).
6.1.26 Message: Please load the User Interface
Please load the User Interface
Edge XNA Small Cabinet 18-000 CoEx XL® brewer User Manual 5DUXNQ20M EN V2.1
100
To Next Page
Loading...
