Message
Solution
Message
Solution
Message
Solution
Message
Solution
Message
6.1.32 Message: Temperature boiler (too) high
Temperature boiler (too) high
1. Open the door of the coffee machine.
2. Insert the service key.
3. Perform the procedure Flush mixers and brewer (on page 54)
several times.
4. If message is still shown: Consult the service engineer (see
Service and support on page 3).
6.1.33 Message: The brewer blocked during recipe, did not reach position
The brewer blocked during recipe, did not reach position.
Perform the following steps to solve the problem:
1. Open and close the door of the coffee machine to initialize
the brewer.
2. Check correct functioning by taking a coffee beverage. If
problem persists: Consult the service engineer (see Service
and support on page 3).
6.1.34 Message: Water level too low
Water level too low
Consult the service engineer (see Service and support on page
3).
6.1.35 Message: Wait, Heating boiler
Wait, Heating boiler
Perform the following steps to solve the problem:
1. Wait until boiler is heated.
2. If message is still shown after 10 minutes: Consult the service
engineer (see Service and support on page 3).
6.1.36 Message: Waste bucket full / Empty waste bucket
Waste bucket full / Empty waste bucket
Edge XNA Small Cabinet 18-000 CoEx XL® brewer User Manual 5DUXNQ20M EN V2.1
102
To Next Page
Loading...
