Solution
Message
Solution
Message
Solution
Message
Cause
Solution
Perform the following steps to solve the problem:
1. Empty waste bucket (see Clean waste bucket on page 55).
▪ If message is still shown, remove the waste bucket and
wait 6 seconds before placing it back.
▪ If message is still shown, check if the waste bucket
detector switch is clean (check the Inside view (on page
17) drawing for the location).
▪ If the problem persists: Consult the service engineer.
6.1.37 Message: Water filter installed?
Water filter installed?
Consult the service engineer (see Service and support on page
3).
6.1.38 Message: Wrong brewer defined in the software
Wrong brewer defined in the software.
1. Consult the service engineer (see Service and support on
page 3).
6.1.39 Message: Ready, take your cup
Ready, take your cup
The dispense of the beverage is finished.
Remove the cup or jug.
103
Edge XNA Small Cabinet 18-000 CoEx XL® brewer User Manual 5DUXNQ20M EN V2.1
To Next Page
Loading...
