Procedure
4.2.1.1 Cup dispensing
Perform the following steps:
1. Tap the desired beverage button from the selections on the
Main menu (see on page 21).
▪ or first tap one of the [Scroll Up/down] buttons and then
select the desired beverage.
2.
The Additional options submenu (on page 24) with the
selected beverage is shown.
3.
When available and needed, tap one or more of the desired
options to make additional changes.
4.
Place a cup under the correct outlet.
▪
check the drawing of the front view (on page 16) for the
correct outlet.
5.
Tap the [Start] button to prepare the beverage.
▪
or tap [Cancel] to return to the Main menu (see on page
21).
▪ when payment mode is activated, full payment is needed
first to enable the [Start] button. Check the payment (on
page 44) section for more details.
6.
The Dispense submenu (see on page 31) is now shown and
the beverage is prepared.
▪ or tap the [Stop] button to interrupt and stop the
dispense.
7. When the dispense is finished the Ready submenu (on page
33) is shown.
▪
do not remove your cup before the message 'Ready, take
your cup (see
Message: Ready, take your cup on page 103)'
is visible. The message will remain visible on the screen
until the cup is removed.
▪ To add an additional beverage to the same cup, do not
remove the cup but tap the [Cancel] button and select the
next beverage.
8. The prepared drink is ready.
WARNING
Hot liquid can leak from the outlet nozzle after the
dispense is finished.
Edge XNA Small Cabinet 18-000 CoEx XL® brewer User Manual 5DUXNQ20M EN V2.1
40
To Next Page
Loading...
