EasyManuals Logo

Defender DVR User Manual

Defender DVR
84 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #50 background imageLoading...
Page #50 background image
50
FINDING YOUR DVR’S IP ADDRESS
By default, the DVR IP mode is set to DHCP. This means the DVR will automatically retrieve an IP address from the router
that it is connected to. Unless your network requires a static IP address leave the DVR IP mode set as DHCP.
1. From the MAIN MENU, select NETWORK.
2. Conrm that the IP MODE is set to DHCP. This setting is acceptable for most users.
• IftheIPmodeisnotsettoDHCP,usethedropdownlistnexttoTYPE and change the type so that it is set to
DHCP. Click APPLY and EXIT to restart the DVR and retrieve an IP address.
3. Write down your IP address, CLIENT PORT, HTTP PORT and GATEWAY. This information will be used in the next
few steps to view the DVR on your computer as well as for viewing the DVR over the Internet.
PREPARING YOUR COMPUTER FOR VIEWING THE DVR
Every computer that is accessing the DVR will need to be congured to download and run ActiveX controls. This
change only needs to be made one time on the computer that is accessing the DVR. This can be done by performing
one of the two following methods. See Viewing your DVR outside your network.
Note: If your router does not support DHCP, contact your network administrator to supply you with
the proper IP information. If the DVR needs to store PPPoE (DSL/ADSL) settings contact your ISP
(Internet Service Provider) for the proper IP address settings.
ONCE ACQUIRED,
YOUR IP ADDRESS
WILL APPEAR HERE
NETWORK GUIDE

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Defender DVR and is the answer not in the manual?

Defender DVR Specifications

General IconGeneral
BrandDefender
ModelDVR
CategoryDVR
LanguageEnglish

Related product manuals