54
VIEWING YOUR DVR FROM OUTSIDE OF YOUR NETWORK
Now that you have successfully viewed your DVR and cameras from a computer connected to the same router, it is time
to set up your router to view the DVR while at a remote location. This process is called PORT FORWARDING and you can
nd detailed instructions on how to complete the required steps at:
Option 1 - www.defender-usa.com/network
Option 2 - www.portforward.com
BEFORE YOU BEGIN PORT FORWARDING YOU WILL NEED:
The DVR connected to a router.
Your computer must be connected to the same network/router as the DVR.
The brand and model number of your router (this is usually located on the
back or bottom of the router).
Internet Explorer® 6.0 or higher.
The Internal IP address of your DVR and the GATEWAY number.
The CLIENT PORT and HTTP PORT numbers that the DVR is programmed to
use. To view which ports are being used with your DVR, see the NETWORK
menu on your DVR.
Note: Port forwarding is required if you want to view the DVR from a computer that is not connected
to the same router.
NETWORK GUIDE
To Next Page
Loading...
Need help?
General
