You must be in List view to set favourite parameters and write individual parameters.
5.2.6 Inputs/Outputs page
The status of inputs and outputs can be monitored on the Inputs/Outputs page. An example is shown below.
5.3 Using the Utility Software
5.3.1 Changing parameters
To change parameters, do the following:
1. Open the Parameters page in either tree or list view.
2. Find the parameter you want to change.
3. If the parameter selects an option:
● In Tree view, change the parameter by selecting the option you want from the drop-down list.
● In List view, double click the parameter line you want to change. A dialogue box containing the drop-
down list opens. Select the option you want.
4. If the parameter selects a value:
● In Tree view, change the parameter by changing the value using the slider. Alternatively, type the val-
ue in the box.
● In List view, double click the parameter line you want to change. A dialogue box containing the value
and a slider opens. Change the value using the slider.
CGC 200 Operator's manual 4189340770
UK
Using the Utility Software
DEIF A/S Page 35 of 43
To Next Page
Loading...
