● Writing the parameter and input and output values as you change them. To do this, open the Parameter
page in List view. Double click on a parameter to open it. Change the parameter and click Write in the
parameter dialogue box.
● Writing all the parameters in the utility software. Select Parameters, then Write ( ). When you are on
the Parameters page, the write icon ( ) is also available on the toolbar.
● Writing information using the batch write function ( ) (described below).
● Restoring the controller information from a .bak file, using Restore Device.
Batch write function
If a CGC 200 file has been saved on the PC, it can be opened, edited and then written to one or more CGC
200s. To use the batch write function:
1. Click the batch read and write icon ( ) on the toolbar.
2. Select Write to device.
3. The Batch job (Writing) dialogue box opens.
Select the information that you would like to write and click Run.
5.3.5 Firmware upgrade
You can use the utility software to upgrade the firmware on the CGC 200.
To upgrade the firmware:
CGC 200 Operator's manual 4189340770
UK
Using the Utility Software
DEIF A/S Page 39 of 43
To Next Page
Loading...
