In List view, double click the parameter line for the input or output you want to change. Select the input or
output you want from the drop-down list in the dialogue box.
5.3.3 Reading from the controller
Parameters, logs and the input and output configuration are stored in the CGC 200. This information can also
be stored in a file on the PC.
You can read from the controller by:
● Connecting to the controller: the utility software automatically reads the information in the CGC 200 after
connection.
● Reading all the parameters from the controller. Select Parameters, then Read (
). When you are on
the Parameters page, the read icon ( ) is also available on the toolbar.
CGC 200 Operator's manual 4189340770
UK
Using the Utility Software
DEIF A/S Page 37 of 43
To Next Page
Loading...
