Deif CGC 200 - Units

A value, or set point, used to determine the controller's operation. Parameters include alarm settings, and the
configuration options for configurable inputs and outputs. The same set of parameters can be uploaded to
several controllers.
6.1.3 Units
The table below lists the units used in the documentation.
Unit Name Measures
A ampere Current
°C degrees Celsius Temperature
g gram Mass
H hour Time
kPa kilopascal Pressure
m metre Distance
mm millimetre Distance
ms millisecond Time
RPM revolutions per minute Speed
s second Time
V volt Voltage
V
ac
volt (alternating current) Voltage (alternating current)
V
dc
volt (direct current) Voltage (direct current)
W watt Power
Ω ohm Resistance
CGC 200 Operator's manual 4189340770
UK
Glossary
DEIF A/S Page 43 of 43