Remove the memory module......................................................... 43
Install the memory module.............................................................44
Install the mid hard drive tray........................................................ 45
Install the system cover.................................................................46
Slide the system into the cabinet...................................................47
Connect the I/O cables and power cords.......................................48
Verifying successful DIMM replacement from the ACM ............... 48
M2 memory remove and replace.................................................................49
Identifying a failed M.2 from the ACM .......................................... 49
Disconnect the power cords and I/O cables.................................. 49
Extend the system from the cabinet..............................................50
Remove the system cover............................................................. 50
Replace an M.2 module.................................................................. 51
Install the system cover.................................................................54
Slide the system into the cabinet.................................................. 55
Connect the I/O cables and power cords...................................... 56
Verifying successful M.2 card replacement from the ACM ........... 56
Remove and replace NIC cards...................................................................57
Network daughter card..................................................................57
Network Interface Controller (NIC) ports......................................57
Identifying a failed NIC from the ACM .......................................... 57
Disconnect the power cords and I/O cables.................................. 58
Extend the system from the cabinet..............................................58
Remove the system cover............................................................. 59
NIC indicator codes....................................................................... 60
Remove the rear hard drive cage...................................................60
Remove the network daughter card............................................... 61
Install the network daughter card.................................................. 62
Install the rear hard drive cage...................................................... 62
Install the network interface card into expansion card riser 1.........63
Install the system cover.................................................................64
Slide the system into the cabinet...................................................65
Connect the I/O cables and power cords...................................... 66
Verifying successful NIC replacement from the ACM ................... 66
Start up the IDPA....................................................................................... 67
Start up the IDPA from Dell server................................................ 67
Start up the IDPA from iDRAC.......................................................67
Document references for the IDPA 69
Service video resources 71
CONTENTS
4 Dell EMC IDPA DP4400 Service Procedures