Dell EMC XC Core XC6515 - Mini PERC Card; Remove the Mini PERC Card; Installing the LOM Riser Card

Figure 74. Installing the LOM riser card
Next steps
1. If removed, install the risers.
2. Install the air shroud.
3. Follow the procedure listed in After you work inside your system.
NOTE:
While replacing faulty storage controller/FC/NIC card with the same type of card, after you power on the
system; the new card automatically updates to the same firmware and configuration of the faulty one. For more
information about the Part replacement configuration, see the Lifecycle Controller User's Guide at www.dell.com/
idracmanuals
Mini PERC card
Remove the mini PERC card
Prerequisites
• Follow the safety guidelines listed in the Safety instructions.
• Follow the procedure listed in the Before you work inside your system.
• Remove the air shroud.
• If installed, remove the risers..
Steps
1. Using a Phillips #2 screwdriver, loosen the screws that secure the cable to the mini PERC card.
2. Holding the tab, lift the cable to disconnect from the mini PERC card.
Installing and removing system components
103