Figure 65. Removing the M.2 SSD module
Next steps
Install the M.2 SSD module
Prerequisites
• Follow the safety guidelines listed in the Safety instructions.
• Follow the procedure listed in the Before working inside your system.
• Remove the air shroud.
• Remove the BOSS card.
NOTE: The procedure to remove the BOSS card is similar to the removing an expansion card.
Steps
1. Align the M.2 SSD module at an angle with the connector on the BOSS card.
2. Insert the M.2 SSD module until it is firmly seated in the BOSS card connector.
3. Using the Phillips #1 screwdriver, secure the M.2 SSD module on the BOSS card with the screw.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
96 Installing and removing system components
To Next Page
Loading...
