Control panel
Remove the left control panel
Prerequisites
• Follow the safety guidelines listed in the Safety instructions.
• Follow the procedure listed in the Before you work inside your system.
• If applicable, Remove the drive backplane cover
• Remove the air shroud.
Steps
1. Disconnect the control panel cable from the system board connector.
NOTE: Observe the routing of the cable as you remove it from the system.
2. Using a Phillips #1 screwdriver, remove the screws that secure the cable cover to the system.
3. Using the Phillips #1 screwdriver, remove the screws that secure the left control panel assembly to the system.
4. Hold the left control panel assembly and remove it from the system.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 93. Removing the left control panel
Next steps
Install the left control panel.
Install the left control panel
Prerequisites
• Follow the safety guidelines listed in the Safety instructions on page 52.
• Follow the procedure listed in the Before working inside your system.
Steps
1. Route the control panel cable through the side wall and the guide slots in the system and connector on system board.
120
Installing and removing system components
To Next Page
Loading...
