Dell EMC XC Core XC6515 - Power Interposer Board; Remove the Power Interposer Board; Install the Power Interposer Board; Removing the Power Interposer Board

Power interposer board
Remove the power interposer board
Prerequisites
• Follow the safety guidelines listed in the Safety instructions.
• Follow the procedure listed in the Before you work inside your system.
• Remove the air shroud.
• Remove the PSU or PSU blank.
Steps
1. Using a Phillips #2 screwdriver, remove the screws securing the power interposer board (PIB) to the system.
NOTE: Observe the routing of the cable as you remove it from the system.
2. Press the blue release latch on the PIB to release it from the hook on the PSU cage.
Figure 89. Removing the power interposer board
3. Lift the PIB away from the system.
Next steps
Replace the power interposer board.
Install the power interposer board
Prerequisites
• Follow the safety guidelines listed in the Safety instructions.
• Follow the procedure listed in the Before working inside your system.
114
Installing and removing system components