Figure 61. Installing an expansion card into a low profile left riser
Figure 62. Installing an expansion card into a low profile right riser
Next steps
1. If applicable, connect the cables to the expansion card.
2. Install the air shroud.
3. Follow the procedure listed in After you work inside your system.
4. Install any device drivers required for the card as described in the documentation for the card.
NOTE:
While replacing faulty storage controller/FC/NIC card with the same type of card, after you power on the
system; the new card automatically updates to the same firmware and configuration of the faulty one. For more
information about the Part replacement configuration, see the
Lifecycle Controller User's Guide
at www.dell.com/
idracmanuals
Installing and removing system components 93
To Next Page
Loading...
