4. Once the tests have been completed, you can view the results and additional information about the Results tab, the System Health
tab, the Configuration tab, and the Event Log tab.
5. Close the Embedded System Diagnostics utility.
6. To leave the diagnostics, click Exit.
7. Click OK when prompted, and the system reboots.
Running the Embedded System Diagnostics from the Dell
Lifecycle Controller
To run the embedded system diagnostics from the Dell Lifecycle Controller:
1. As the system boots, press F10.
2. Select Hardware Diagnostics → Run Hardware Diagnostics.
System diagnostics and indicator codes
155
To Next Page
Loading...
