Dell 1135N - Firmware Upgrade Procedures

Alignment and Troubleshooting
4-22
Service Manual
4.1.8 Firmware Upgrade
♦ USB and Network port are used to update the firmware.
Network applications (SWAS, SWS) can be used to update the firmware.
♦ Normal Update
Send ROM file via USB, network port in Ready state.
It will automatically update and reset.
♦ Special Mode Update
1. Power On While Pressing “Stop / Clear” Button.
- It displays download mode message.
2. Send ROM file via USB.
3. It will automatically update and reset.
Note
* You can refer to the F/W Version Info. by pressing “ Menu → # → 1 → 9 → 3→ # ”
* If the machine is still not fyou cannot necessary you should perform factory clearing
“ Menu → # → 1 → 9 → 3 → Start ” (Dell 1135n)
#
“ Menu → ID Copy → Left → Right → Menu → Start ” (Dell 1133)#after updating Rom file.
Notice : All of count values and data saved in MFP will be cleared.