Dell 6100 - System Board Configuration Options; Figure 5-3. Change Configuration Settings Menu

5-8 Dell PowerEdge 6100/200 System User’s Guide
Figure 5-3. Change Configuration Settings Menu
3. To view or change the settings for a particular
card, highlight the name of the card and press
<Enter>.
A list of options appears on the screen.
To select a category on the list of system board
options, press the up- or down-arrow key to high-
light the category and press <Enter>. A pop-up menu
appears, listing the options for that category. To
select an option, press the up- or down-arrow key to
highlight the option and press <Enter>.
NOTES: Several system board categories allow you
to edit such resources as memory address, I/O ports,
IRQs, and DMA channels. It may be necessary to
edit these resources to resolve a configuration
conflict.
The Change Configuration Settings feature is
intended for users who are technically knowledge-
able. Do not change resource settings from their
defaults if you do not understand how such a change
will affect system performance.
While in the Change Configuration Settings menu,
you can press <F9> to enter the Advanced Options
menu. See “Advanced Options Menu” later in this
chapter for more information.
4. Select Step 4: Save Configuration to save your
changes.
5. Press <Esc>, select Step 6: Exit, and follow the
online instructions.
Remember to save a written copy of the new
information.
System Board Configuration Options
Categories related to the system board are organized into
the following major groups:
•
Systems Group
•
Memory Subsystem Group
•
On-Board Disk Controllers
•
On-Board Communication Devices
•
Floppy Drive Subsystems Group
Step 3: Change Configuration Settings
System Board System Board
PCI RAM Device Bus 0 Dev 14
PCI SCSI Device Bus 1 Dev C
PCI SCSI Device Bus 1 Dev B
- This step is optional, you may skip it by pressing ESC and all
configuration settings will remain unchanged.
- Press ENTER to view or change a board’s configuration settings.
- Press ESC when you are satisfied with the current settings.
[Select=ENTER] [Remove=DEL] [Done=ESC] [Advanced Options=F9] [Help=F1]
[ISA/EISA Lock Toggle=F8]