System board
Removing the system board
Prerequisites
1. Follow the procedure in
Before working inside your computer.
2. Remove the base cover.
3. Remove the 2230 solid-state drive in M.2 slot one, if installed.
4. Remove the
2280 solid-state drive in M.2 slot one, if installed.
5. Remove the 2230 solid-state drive in M.2 slot two, if installed.
6. Remove the 2280 solid-state drive in M.2 slot two, if installed.
7. Remove the
rear I/O-cover.
8. Remove the battery.
About this task
The following image indicates the location of the system board and provides a visual representation of the removal procedure.
45
To Next Page
Loading...
