6. Remove the 2280 solid-state drive in M.2 slot two, if installed.
7. Remove the speakers.
8. Remove the rear I/O-cover.
9. Remove the battery.
10.Remove the
display assembly.
11. Remove the keyboard-controller board.
12. Remove the right I/O-board.
13. Follow step 1 to step 21 in removing the
system board.
14. Remove the touchpad.
15.Remove the power-adapter port.
16.Remove the power-button assembly.
17. Remove the keyboard.
Steps
After performing the pre-requisites, you are left with the palm rest.
Installing the palm rest
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
Steps
To install the palm rest, perform the post-requisites.
63
To Next Page
Loading...
