Steps
1. Using the alignment pins, place the interposer board on the system board.
2. Using the alignment pins, connect the left I/O-board to the system board through the interposer board.
3. Align the screw holes on the left I/O-board with the screw holes on the system board and interposer board.
4. Replace the four screws (M2x4.5) that secure the left I/O-board to the system board.
Next steps
1. Follow step 3 to step 22 in installing the
system board.
2. Install the battery.
3. Install the rear I/O-cover.
4. Install the 2280 solid-state drive in M.2 slot two, if installed.
5. Install the
2230 solid-state drive in M.2 slot two, if installed.
6. Install the 2280 solid-state drive in M.2 slot one, if installed.
7. Install the 2230 solid-state drive in M.2 slot one, if installed.
8. Install the base cover.
9. Follow the procedure in
After working inside your computer.
Fan and heat-sink assembly
Removing the fan and heat-sink assembly
Prerequisites
1. Follow the procedure in
Before working inside your computer.
2. Remove the base cover.
3. Remove the
2230 solid-state drive in M.2 slot one, if installed.
4. Remove the 2280 solid-state drive in M.2 slot one, if installed.
5. Remove the 2230 solid-state drive in M.2 slot two, if installed.
6. Remove the 2280 solid-state drive in M.2 slot two, if installed.
7. Remove the rear I/O-cover.
8. Remove the battery.
9. Follow step 1 to step 21 in removing the system board.
51
To Next Page
Loading...
Need help?
General