Steps
1. Place the display assembly over the palm-rest and keyboard assembly and align the screw holes on the display hinges to the
screw holes on the palm-rest and keyboard assembly.
2. Replace the four screws (M2.5x5) that secure the display assembly to the palm-rest and keyboard assembly.
3. Route the display cable and camera cable through the routing guides on the display assembly.
4. Turn over the computer.
5. Connect the display cable to the connector on the system board and close the latch.
6. Adhere the tape that secures the display-cable connector latch to the system board.
7. Replace the two screws (M2.5x5) that secure the power-adapter port-bracket to the palm-rest and keyboard assembly.
8. Move the power-adapter port cable back into place over the system board.
9. Adhere the tapes that secure the power-adapter port cable to the system board.
10. Conect the camera cable to the connector on the system board and close the latch.
11. Adhere the tape that secures the camera-cable connector latch to the system board.
12. Replace the two screws (M2.5x5) that secure the left-display hinge to the palm-rest and keyboard assembly.
Next steps
1. Install the rear-I/O cover.
2. Install the base cover.
46
Removing and installing components
To Next Page
Loading...
Need help?
General