Steps
1. Place the I/O board on the palm-rest and keyboard assembly and align the screw holes on the I/O board to the screw holes
on the palm-rest and keyboard assembly.
2. Replace the four screws (M2x3) that secure the I/O board to the palm-rest and keyboard assembly.
Next steps
1. Install the system board.
2. Install the heat pipe.
3. Install the left fan.
4. Install the right fan.
5. Install the headset port.
6. Install the power-adapter port.
7. Install the rear-I/O cover.
8. Install the battery.
9. Install the base cover.
10. Follow the procedure in After working inside your computer.
Keyboard bracket
Removing the keyboard bracket
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the memory.
4. Remove the battery.
5. Remove the rear-I/O cover.
6. Remove the power-adapter port.
7. Remove the headset port.
8. Remove the speakers.
64
Removing and installing components
To Next Page
Loading...
Need help?
General