Steps
1. Place the fan and heat-sink assembly on the system board.
2. Align the screw holes on the fan and heat-sink assembly to the screw holes on the system board.
3. In sequential order (1>2>3>4>5>6>7>8) tighten the eight captive screws (M2x3) that secure the fan and heat-sink
assembly to the system board.
4. Connect the left and right heat-sink assembly fan cables to the system board.
Next steps
1. Install the system board.
2. Install the heat pipe.
3. Install the left fan.
4. Install the right fan.
5. Install the headset port.
6. Install the power-adapter port.
7. Install the rear-I/O cover.
8. Install the battery.
9. Install the base cover.
10. Follow the procedure in After working inside your computer.
Power button
Removing the power button
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
60
Removing and installing components
To Next Page
Loading...
Need help?
General