Steps
1. Using the alignment posts, place the power button into its slot on the palm-rest and keyboard assembly.
2. Place the power-button bracket over the power button and align the screw holes on the power-button bracket to the screw
holes on the palm-rest and keyboard assembly.
3. Replace the screw (M2x3) that secures the power-button with optional fingerprint reader to the palm-rest and keyboard
assembly.
Next steps
1. Install the system board.
2. Install the heat pipe.
3. Install the left fan.
4. Install the right fan.
5. Install the headset port.
6. Install the power-adapter port.
7. Install the rear-I/O cover.
8. Install the battery.
9. Install the base cover.
10. Follow the procedure in After working inside your computer.
I/O board
Removing the I/O board
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
4. Remove the rear-I/O cover.
5. Remove the power-adapter port.
62
Removing and installing components
To Next Page
Loading...
Need help?
General