Installing the base cover
1 Toe in the base cover front edge into the system.
2 Press the edges of the cover until it clicks into place.
3 Replace the M2.5x7.5 screws to secure the base cover to the system.
4 Install the microSD card.
5 Follow the procedure in After working inside your computer.
Battery
Removing the battery
1 Follow the procedure in Before working inside your computer.
2 Remove the:
a microSD card
b base cover
3 To remove the battery:
a Remove the single (M2x3) screw and lift the right metal bracket that secures the battery cable to the system board [1, 2].
b Peel the adhesive tape that secures the keyboard cable in place [3].
c Disconnect the keyboard cable from the connector in the system board [4].
12
Removing and installing components
To Next Page
Loading...
