Dell D13M - Installing the Hard Drive Assembly; Removing the Optical Drive

5 Repeat steps 3 and 4 to remove the second optical drive (if available).
Installing the optical drive
1 Slide the optical drive into the drive bay from the front of the computer until it is secured.
2 Connect the data cable and power cable to the optical drive.
3 Install:
a front bezel
b cover
4 Follow the procedure in After Working Inside Your Computer.
Removing power switch
1 Follow the procedure in Before working inside your computer.
2 Remove the:
a Side cover
b Front bezel
c HDD assembly
d Optical drive module
3 To remove the power switch:
a Disconnect the power switch cable from the system board [1].
b Unroute the power switch cable, from the routing clips on the system chassis [2] [3].
10
Removing and installing components