Installing the power switch
1 Align and slide the power switch module into the slot on the chassis until it clicks into place.
NOTE
: Ensure that the power switch cable is routed correctly through the cable routing clips on the system chassis.
2 Connect the power switch cable to the connector on the system board.
3 Install the:
a Optical drive module
b HDD assembly
c Front bezel
d Side cover
4 Follow the procedure in After working inside your computer.
Removing the intrusion switch
1 Follow the procedure in Before Working Inside Your Computer.
2 Remove the cover.
3 To remove intrusion switch:
a Press the tab to disconnect the intrusion switch cable from the system board [1, 2].
b Slide the knob of the intrusion switch toward the bottom of the chassis [3].
12
Removing and installing components
To Next Page
Loading...
