Dell D13M - Installing the System Fan; Removing the Heat Sink Assembly

Installing the expansion card
1 Insert the expansion card in the connector on the system board and press it until clicks into place.
2 Close the release latch.
3 Install the cover.
4 Follow the procedure in After Working Inside Your Computer.
Removing the system fan
1 Follow the procedure in Before Working Inside Your Computer.
2 Remove the cover.
3 To remove the system fan:
a Disconnect the system fan cable from the system board [1].
b Stretch the grommets securing the fan to the computer to ease the removal of the fan [2].
c Slide and lift the system fan from the computer [3].
Removing and installing components
19