5 Install the cover.
NOTE: If you assign a new system and/or setup password with the PSWD jumper installed, the system disables the new
password(s) the next time it boots.
6 Connect the computer to the electrical outlet and power-on the computer.
7 Power-o the computer and disconnect the power cable from the electrical outlet.
8 Remove the cover.
9 Replace the PSWD jumper on the system board.
10 Install the cover.
11 Follow the procedures in After Working on Your Computer.
12 Power-on the computer.
13 Go to the system setup, and assign a new system or setup password. See Setting up a System Password.
36 System Setup
To Next Page
Loading...
