Dell D13M - Removing the Power Supply Unit (PSU)

Removing the PCIe Solid State Drive SSD
1 Remove the screw that secures the PCIe SSD card.
2 Slide and lift the PCIe SSD card from the computer.
3 Lift the thermal pad from the system board.
4 Install the:
a optical drive
b hard drive
c cover
5 Follow the procedure in After Working Inside Your Computer.
Removing the power supply unit PSU
1 Follow the procedure in Before Working Inside Your Computer.
2 Remove the cover.
3 Press the tab of the 4-pin power cables and disconnect it from the system board [1,2].
4 Release the cables from the clip [3].
5 To remove the power supply unit (PSU):
a Remove the screws that secure the PSU to the computer [1].
Removing and installing components
15