Installing the Input-Output panel
1 Insert the I/O panel into the slot on the front of the chassis.
2 Slide the I/O panel toward the right of the computer to secure it to the chassis.
3 Tighten the screw to secure the I/O panel to the chassis.
4 Connect the I/O panel, and USB data cable to the system board.
5 Install :
a front bezel
b cover
6 Follow the procedure in After Working Inside Your Computer.
Removing the speaker
1 Follow the procedure in Before Working Inside Your Computer.
2 Remove the cover.
3 To remove the speaker:
a Disconnect the speaker cable from system board [1].
b Press the securing tab on the speaker to slide and remove the speaker from the chassis [2, 3].
Removing and installing components
17
To Next Page
Loading...
