Dell D13M - Installing the Memory Module; Installing the Pcie Solid State Drive (SSD)

c Pull the intrusion switch to remove it from the slot [4].
Installing the intrusion switch
1 Insert the intrusion switch into the slot in the chassis.
2 Slide the intrusion switch to secure it.
3 Connect the intrusion switch cable to the system board.
4 Install the cover.
5 Follow the procedure in After Working Inside Your Computer.
Removing the memory module
1 Follow the procedure in Before Working Inside Your Computer.
2 Remove the cover.
3 Press the memory module retention tabs on each side of the memory module.
4 Lift the memory module out of the connectors on the system board.
Installing the memory module
1 Align the notch on the memory module with the tab on the memory module connector.
2 Insert the memory module into the memory module socket.
3 Press the memory module until the retention tabs clicks into place.
4 Install the cover.
5 Follow the procedure in After Working Inside Your Computer.
Removing and installing components
13