Dell D13M - Removing the Pcie Solid State Drive (SSD)

Installing the PCIe Solid State Drive SSD
NOTE: The PCIe SSD card is shipped with the following components:
1 PCIe SSD card
2 Thermal Pad
3 Screw
1 Follow the procedure in Before Working Inside Your Computer.
2 Remove the:
a cover
b hard drive
c optical drive
3 Peel the blue adhesive tape from the thermal pad.
4 Place the thermal pad in the slot on the system board and peel the pink adhesive tape [1,2].
5 Slide the PCIe SSD card into the slot and tighten the screw to secure the card to the system board [1,2].
14
Removing and installing components