Dell D13M - Page 27

Option Description
Date/Time Allows you to set the date and time. The changes to the system date and time takes eect
immediately.
Table 4. System conguration
Option Description
Integrated NIC Allows you to congure the integrated network controller. The options are:
• Enable UEFI Network Stack
• Disabled
NOTE: You can use the Disabled option, only if Active Management Technology
(AMT) option is disabled.
• Enabled
• Enabled w/PXE (Default)
• Enabled w/Cloud Desktop
Serial Port Identies and denes the serial port settings. You can set the serial port to:
• Disabled
• COM1 (Default)
• COM2
• COM3
• COM4
NOTE: The operating system may allocate resources even if the setting is disabled.
SATA Operation Allows you to congure the internal SATA hard-drive controller. The options are:
• Disabled
• AHCI
• RAID On (Default)
Drives Allows you to congure the SATA drives on board. The options are:
• SATA-0
• SATA-1
• SATA-2
• M.2 PCIe SSD-0
Default Setting: All drives are enabled.
SMART Reporting This eld controls if the hard drive errors for the integrated drives are reported during system
startup. This technology is part of the SMART (Self Monitoring Analysis and Reporting Technology)
specication.
• Enable SMART Reporting - This option is disabled by default.
USB Conguration Allows you to enable or disable the USB conguration. The options are:
• Enable Boot Support
• Enable Front USB Ports
• Enable rear USB Ports
Front USB Conguration Allows you to enable or disable the Front USB conguration. The options are:
• Front Port 1
• Front Port 2
System Setup 27