Steps
1 Using the Phillips #2 screwdriver, remove the screws that secure the riser card to the expansion card bracket.
2 Lift the riser card away from the expansion card bracket.
Figure 47. Removing the riser card
Next step
Install the riser card.
Related link
Removing a sled
Removing the expansion card riser assembly
Removing an expansion card
Installing the riser card
Installing the riser card
Prerequisite
1 Follow the safety guidelines listed in Safety instructions.
Steps
1 Place the riser card into the expansion card bracket.
2 Using the Phillips #2 screwdriver, tighten the screws that secure the riser card to the expansion card bracket.
Installing and removing system components
101
To Next Page
Loading...
