Dell EMC PowerEdge C6420 - Removing the Expansion Card Riser Assembly

Location Card type Form factor Link width Slot priority Maximum number of
cards
Slot 4 SolarFlare Flareon
SFN8522 10GE SFP
Dual Port Adapter
Low prole x8 4 1
Slot 4 Intel 10GbE Quad
Port X710-t Adapter
Low prole x8 4 1
Slot 4 Intel Gigabit Dual
Port I350-t Adapter,
1GB
Low prole x4 4 1
Slot 4 Broadcom 5720 DP
1G Adapter,
1000Mbps
Low prole x1 4 1
Removing the expansion card riser assembly
Prerequisites
NOTE: You must install an expansion card ller bracket over an empty expansion slot to maintain Federal Communications
Commission (FCC) certication of the system. The brackets also keep dust and dirt out of the system and aid in proper cooling
and airow inside the system.
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
3 Remove the sled from the enclosure.
Steps
1 Remove the screws that secure the expansion card riser assembly.
2 Lift the expansion card riser assembly out of the sled.
Figure 41. Removing the expansion card riser assembly
Next step
Install the expansion card riser assembly.
Installing and removing system components
95