Figure 56. Installing the mezzanine card bridge board
Next steps
1 Install the mezzanine card.
2 Install the expansion card riser assembly.
3 Install the sled into the enclosure.
4 Follow the procedure listed in After working inside your system.
Related link
Installing a mezzanine card
Installing the expansion card riser assembly
Installing a sled
Removing the OCP card
Prerequisites
NOTE
: The procedure to remove the mezzanine blank is similar to the removal of a mezzanine card.
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
3 Remove the sled from the enclosure.
4 Remove the mezzanine card.
Steps
1 Push the blue retention clips away on one side and release the Open Compute Project (OCP) card.
Repeat step 1 to release the card from the clips on the other side.
2 Slide the card toward the front of the sled to disengage the connectors from the chassis and lift the card up.
Installing and removing system components
111
To Next Page
Loading...
