Dell EMC PowerEdge C6420 - Installing the Air Shroud

Figure 18. Removing the air shroud
Next step
Install the air shroud.
Related link
Removing a sled
Installing the air shroud
Installing the air shroud
Prerequisite
1 Follow the safety guidelines listed in Safety instructions.
Steps
1 Insert the air shroud into the sled, aligning the shroud hinge with slot on the sled chassis.
NOTE
: Ensure that both the SATA cables are routed through the air shroud cable guide slot behind the air shroud
latches.
NOTE: Ensure that neither of the cables are pinched or pressed under the air shroud.
2 Press the air shroud until the locks click into place.
70
Installing and removing system components