Table 4. System health and system ID indicator codes
System health and system ID indicator code Condition
Solid blue
Indicates that the system is turned on, system is healthy, and
system ID mode is not active. Press the system health and
system ID button to switch to system ID mode.
Blinking blue Indicates that the system ID mode is active. Press the system
health and system ID button to switch to system health mode.
Solid amber Indicates that the system is in fail-safe mode. If the problem
persists, see Getting help on page 126.
Blinking amber Indicates that the system is experiencing a fault. Check the
System Event Log or the LCD panel, if available on the bezel,
for specific error messages. For more information about error
messages, see the Dell Event and Error Messages Reference
Guide at Dell.com/openmanagemanuals > OpenManage
software.
iDRAC Quick Sync 2 indicator codes
iDRAC Quick Sync 2 module (optional) is located on the on the left control panel of your system.
Figure 5. iDRAC Quick Sync 2 indicators
Table 5. iDRAC Quick Sync 2 indicators and descriptions
iDRAC Quick Sync 2 indicator
code
Condition Corrective action
Off (default state) Indicates that the iDRAC Quick Sync 2
feature is turned off. Press the iDRAC
Quick Sync 2 button to turn on the
iDRAC Quick Sync 2 feature.
If the LED fails to turn on, reseat the left
control panel flex cable and check. If the problem
persists, see Getting help on page 126.
Solid white Indicates that iDRAC Quick Sync 2 is
ready to communicate. Press the iDRAC
Quick Sync 2 button to turn off.
If the LED fails to turn off, restart the system.
If the problem persists, see Getting help on page
126.
Blinks white rapidly Indicates data transfer activity. If the indicator continues to blink indefinitely, see
Getting help on page 126.
Blinks white slowly Indicates that firmware update is in
progress.
If the indicator continues to blink indefinitely, see
Getting help on page 126.
Blinks white five times rapidly
and then turns off
Indicates that the iDRAC Quick Sync 2
feature is disabled.
Check if iDRAC Quick Sync 2 feature is
configured to be disabled by iDRAC. If the
problem persists, see Getting help on page
126. For more information, see Integrated Dell
Remote Access Controller User's Guide at
Dell.com/idracmanuals or Dell OpenManage
Server Administrator User’s Guide at Dell.com/
openmanagemanuals.
Solid amber Indicates that the system is in fail-safe
mode.
Restart the system. If the problem persists, see
Getting help on page 126.
Blinking amber Indicates that the iDRAC Quick Sync 2
hardware is not responding properly.
Restart the system. If the problem persists, see
Getting help on page 126.
10 XC640 Series and XC Core system overview
To Next Page
Loading...
