4. Holding the control panel by its sides, remove the control panel away from the system.
Next steps
Install the right control panel.
Installing the right control panel
Prerequisites
Follow the safety guidelines listed in Safety instructions on page 55.
Steps
1. Route the control panel cable through the side wall of the system.
2. Align the control panel with the control panel slot on the system and attach the control panel to the system.
3. Connect the control panel cable to the system board and secure it using cable latch.
4. Using Phillips #1 screwdriver, install the screw that secures the control panel to the system.
Figure 82. Installing the right control panel
5. Using Phillips #1 screwdriver, install the screws that secure the cable cover to the system.
118
Installing and removing system components
To Next Page
Loading...
