Installing the integrated storage controller card
Prerequisites
Follow the safety guidelines listed in Safety instructions on page 55.
Steps
1. Angle the integrated storage controller card and align the end of the card with the controller card connector on the system
board.
2. Lower the connector side of the integrated storage controller card into the integrated storage controller card connector on
the system board.
NOTE: Ensure that the slots on the system board align with the screw holes on the integrated storage controller card
connector.
Figure 51. Installing the integrated storage controller card
3. Route the integrated storage controller card cable along the wall of the system.
4. Align the screws on the integrated storage controller card cable with the screw holes on the connector.
5. Using Phillips #2 screwdriver, tighten the screws to secure the integrated storage controller card cable to the card
connector on the system board.
92
Installing and removing system components
To Next Page
Loading...
