Dell EMC XC640 Series - Removing an expansion card from the expansion card riser

NOTE: While installing riser 1 B, press the tabs and hold the touch point to align the expansion card riser and the riser
guide pin on the system board.
3. Lower the expansion card riser into place until the expansion card riser connector is fully seated in the connector.
Figure 37. Installing the expansion riser 1A
Figure 38. Installing the expansion riser 2A
Next steps
1. Follow the procedure listed in After working inside your system on page 56.
2. Install any device drivers required for the card as described in the documentation for the card.
Removing an expansion card from the expansion card riser
Prerequisites
1. Follow the safety guidelines listed in Safety instructions on page 55.
82
Installing and removing system components