Dell EMC XC640 Series - Right Control Panel View

Right control panel view
Figure 6. Right control panel
Table 6. Right control panel
Item Indicator or button Icon Description
1 Power button
Indicates if the system is turned on or off. Press the
power button to manually turn on or off the system.
NOTE: Press the power button to gracefully
shut down an ACPI-compliant operating system.
2
USB port
The USB ports are 4-pin, 2.0-compliant. These
ports enable you to connect USB devices to the
system.
3
iDRAC Direct LED N/A The iDRAC Direct LED indicator lights up to indicate
that the iDRAC Direct port is actively connected to
a device.
4
iDRAC Direct port
The iDRAC Direct port is micro USB 2.0-compliant.
This port enables you to access the iDRAC Direct
features. For more information, see the Integrated
Dell Remote Access Controller User’s Guide at
Dell.com/idracmanuals.
iDRAC Direct LED indicator codes
The iDRAC Direct LED indicator lights up to indicate that the port is connected and is being used as a part of the iDRAC
subsystem.
You can configure iDRAC Direct by using a USB to micro USB (type AB) cable, which you can connect to your laptop or tablet.
The following table describes iDRAC Direct activity when the iDRAC Direct port is active:
Table 7. iDRAC Direct LED indicator codes
iDRAC Direct LED
indicator code
Condition
Solid green for two
seconds
Indicates that the laptop or tablet is connected.
Flashing green (on for
two seconds and off for
two seconds)
Indicates that the laptop or tablet connected is recognized.
Turns off Indicates that the laptop or tablet is unplugged.
XC640 Series and XC Core system overview 11