Dell EMC XC640 Series - Installing the processor into a processor and heat sink module

Figure 29. Loosening the processor bracket
4. Lift the bracket and the processor away from the heat sink, and place the processor connector side down on the processor
tray.
5. Flex the outer edges of the bracket to release the processor from the bracket.
NOTE: Ensure that the processor and the bracket are placed in the tray after you remove the heat sink.
Figure 30. Removing the processor bracket
Next steps
Install the processor into the processor and heat sink module .
Installing the processor into a processor and heat sink module
Prerequisites
Follow the safety guidelines listed in Safety instructions on page 55.
Installing and removing system components
75