Figure 79. Installing the cable cover
Next steps
1. Install the air shroud.
2. If applicable, install the cooling fan #1.
3. Follow the procedure listed in After working inside your system on page 56.
Removing the right control panel
Prerequisites
1. Follow the safety guidelines listed in Safety instructions on page 55.
2. Follow the procedure listed in Before working inside your system on page 56.
NOTE:
Ensure that you note the routing of the cables as you remove them from the system board. You must route the
cables properly when you replace them to prevent the cables from being pinched or crimped.
3. For ease of removal of the right control panel, remove the cooling fan #8 to access the cable latch.
Steps
1. Pull the cable latch and disconnect the control panel cable from the system board connector.
2. Using Phillips #1 screwdriver, remove the screws that secure the cable cover.
Figure 80. Removing the cable cover
3. Using Phillips #1 screwdriver, remove the screws that connect the control panel to the system.
Figure 81. Removing right control panel
Installing and removing system components
117
To Next Page
Loading...
