Figure 44. Installing an expansion card into the expansion riser 2A
Next steps
1. After installing a card into the riser 1, close the PCIe card holder latch. If applicable, close the PCIe guide after installing the
expansion card.
2. Follow the procedure listed in After working inside your system on page 56.
3. Install any device drivers required for the card as described in the documentation for the card.
IDSDM/vFlash card
The IDSDM/vFlash card combines the IDSDM and/or vFlash features into a single module.
Removing a micro SD card
Prerequisites
1. Follow the safety guidelines listed in Safety instructions on page 55 .
2. Follow the procedure listed in Before working inside your system on page 56 .
Steps
1. Locate the SD card slot on the IDSDM module, and press the card to partially release it from the slot.
2. Hold the SD card and remove it from the slot.
NOTE: Temporarily label each SD card with its corresponding slot number after removal.
Next steps
Install a micro SD cards .
Installing a micro SD card
Prerequisites
Follow the safety guidelines listed in Safety instructions on page 55.
86
Installing and removing system components
To Next Page
Loading...
