Dell EMC XC640 Series - Page 83

2. Follow the procedure listed in Before working inside your system on page 56.
3. If applicable, remove the air shroud.
4. If applicable, disconnect the cables from the expansion card.
NOTE: When removing a card from the riser 1, open the PCIe card holder latch. If applicable, remove the PCIe guide and
then remove the expansion card.
Steps
1. If applicable, lift the expansion card latches out of the slot.
2. Hold the expansion card by its edges, and pull the card until the card edge connector disengages from the expansion card
connector on the riser.
Figure 39. Removing an expansion card from riser 1A
Figure 40. Removing an expansion card from riser 2A
3. If you are removing the card permanently, install a metal filler bracket over the empty expansion slot opening and close the
expansion card latch.
Installing and removing system components
83